Poulan 1400T - Manual (Page 11)

B. OPERATING mSTRUCTlONS
1 . Brii^the engine tocutting speed before enteringthe
material to be cut.
a. Do not run the engine at a higher speed than
necessary. The cutting line will cut efficiently
when the engine is run at less than full throttle.
At lower speeds there is less engine noise and
vibration. The trimmer line will last longer and
will be less likely to “weld” onto the spool.
b. If the Trhnmer Head does not turn when the
engine is accelerated^ make sure the Drive Shaft
Housing is properly seated in the Engine Shroud.
Refer to “Assembly-Drive Shaft Housing.”
2 , To stop the engine:
a. Release the Throttle Trigger.
b. Push “Off” Button.
Hold button dovm until the
engine stops. Rgure9.
Figured
USING YOUR TRIMMER
thrown
OBJECl
AWARNING '■> THROWSOBJECTS
The rapidly moving line causes objects to be thrown violently.
The shield will not provide complete protection to the operator
or others. The operator must wear a safety face shield or
goggles. Always wear heavy, long pants and boots. Keep
others at least 30 feet away.
AWARNING HAZARDZONE
This tool will throw objects and cut. Keep others including
children, animals,bystanders, and helpers at least 30 feet
away from the operator and tool. Stop the engine if you are
approached.
Ihp-N-Go n™ IVimmer Head
#952-701604
Use Only Genuine Weed Eater® Parts
AWARNING — DAMAGED TRIMMER
HEAD
Trimmer head parts that are chipped, cracked, or damaged
in any way can fly apart and cause serious injury. Do not
use. Throw damaged parts away. Replace damaged parts
before using the tool.
U