Flails, Carburetor adjustment, Off-season storage – MTD 243-645A000 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
When reassembling the blade, tighten to betwfsen 550
and 650 inch pounds, or lacking torque wrenci, tight
en securely.
FLAILS
The flails, located inside the housing, nay be
reversed when they become dull. It is sugges ed that
this procedure be performed by your nearest autho
rized dealer.
CARBURETOR ADJUSTMENT
A
WARNING: If any adjustments arc made
to the engine while the engine is r jnning
(e.g. carburetor), keep clear of all i rioving
parts. Be careful of heated surfaces and
muffler.
Minor carburetor adjustment may be required o com
pensate for differences in fuel, temperature, altitude
or load.
NOTE: A dirty air cleaner will cause engine to run
rough. Be certain air cleaner is clean and attached to
the carburetor before adjusting carburetor.
Do not make unnecessary adjustments. Factory set
tings are satisfactory for most applications and condi
tions. If adjustment is needed, refer to the separate
engine manual packed with your shredder.
OFF-SEASON STORAGE
The following steps should be taken to prepare your
shredder for storage.
1. Clean and lubricate the shredder thoroughly as
described in the lubrication instructions.
2. Refer to engine manual for correct engine storage
instructions.
3. If storing in an unventilated or metal storage
shed, coat metal parts with a light oil or silicone to
prevent rust.
4. Store in a dry, clean area. Do not store next to
corrosive materials, such as fertilizer.