P„s.ic a, Startert – MTD 113-080A User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
6
.
FIGURE 9.
Place the throttle control lever on the handle
in “Fast” position.
Push the throttle control lever on the engine
to the full open position (as far toward the out
side of the unit as it will go) as shown in figure
9.
7. Hook the “Z” end of the throttle control cable
into the hole in the control lever on the
engine.
Loosen (do not remove) the screw on the
cable clamp shown in figure 9. Slip the control
casing under the clamp. With the throttle lever
on the engine still in the full open position,
tighten the screw to secure the throttle con
trol cable.
8
.
9. Secure throttle control cable and brake cable
to upper and lower handles with cable ties (I).
— See figure 10.
FIGURE 10.
P„s.ic A
Cover
StarterT^
Starter
Housing
Rope
10. The starter rope and handle may be secured
with a plastic cover for shipping purposes.
Remove the plastic cover and discard. See
------figure 11.
11. With the spark plug wire disconnected and
grounded, depress the blade control handle
and pull the starter rope out from the engine.
FIGURE 11.