MTD 216-100A - Manual (Page 5)

7. Dip oil seals in lubricant and then insert one in
gear case and one in bearing cap.
8. Wipe tine shaft clean of filings and lubricate be­
fore assembling with bearings and worm wheel
in gear case.
9. Replace bearing cap.
A
CAUTION
Do not damage oil seals. The open
flanges face to the outside of the gear
case.
10. Tighten bearing cap, retighten screws evenly.
11. Replace tine assemblies and add lubricant. (See
page 4.)
General—Check periodically all nuts and bolts. Loose
nuts and bolts can cause permanent damage to your
unit. Keep all nuts and bolts securely tightened.
Storage—The following steps should be taken to pre­
pare your tiller for storage.
1. Clean tiller thoroughly and lubricate as described
in the preceding instructions.
2. Coat tilling tines with grease to prevent rusting.
3. Prepare engine for storage in accordance with en­
gine manufacturer's owner's guide.
4. Block tiller legs to raise tires clear of floor. Be sure
tiller is level.
5. Store in a dry, clean area.
AHACHMENTS
Extension Tines—This attachment is available to in­
crease your tilling width up to 40". Extension tines are
easily installed and removed. Order under part num­
ber 296-162A.
Furrow Opener—This attachment is easily installed on
the depth bar of your tiller. It can be used for either
furrowing or hilling operations. These attachments are
available through your local dealer.
For wide (2" x .43") depth bar, order furrow opener
296-179A.