MTD 110-518R000 - Manual (Page 9)

2. Slide the ends of the front frame assembly into the
—ends of the rear frame as shown in figure 10A.
3. Secure front of bag to front frame by slipping
plastic channels on sides and bottom of bag over
frame. See figure 10B.
4. Attach the hardtop cover to the grass catcher as
—follows. See figure 11.
a. Place the cover in position on top of the grass
catcher. Press the rear frame into the channel
on the rear of the cover (beneath the rear
handle).
b. Slide the notches on the sides of the cover over
the front catcher frame.
c. Attach rear of cover to frame using the flat
washer and one self-tapping screw as shown
in figure 11. Attach the sides of the cover to
frame with the other two self-tapping screws.
Assemble the locking lever as follows:
a. Place wave washer on shoulder bolt (crowned
side of washer goes against the head of bolt).
b. Insert shoulder bolt up through hole in hardtop
----- cover as shown in figure 12. Place “star”
washer over shoulder bolt.
c. Thread shoulder bolt into the grass catcher
locking lever, using a 9/16" socket wrench. Do
not overtighten. Locking lever must be able to
pivot.