Assembly grass catcher – MTD 111-328-300 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(C)
■6. Secure throttle control cable to handle with
cable ties (C) provided. See figure 6.
7. Check ail nuts and bolts for correct tightness.
FIGURE 6.
Rear
Frame
ASSEMBLY
Grass Catcher
1. Connect the front and rear frames by pushing
— the tubing connectors onto the ends of the
rear frame. See figure 7.
FIGURE 7.
Start Bolts (G)
Lock Washers (H)
and Hex Nuts (I)
2. Slip frame into grass bag. The black plastic is
the bottom of the grass bag. Fasten edges of
bag (with eyelets) to front frame with 3/8"
— bolts (G), lock washers (H) and hex nuts (I).
Finger tighten. See figure 8. Hint: For easier
assembly Do Not fasten lower bolts on sides
until after step 3.
FIGURE 8.