MTD 215-395A User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WHEEL
HANGEI
FIGURE 2. WHEEL ASSEMBLY
Step 3. Place the wheel hanger into the tailpiece and
secure with the long clevis pin (D) and locking
pin (E). See figure 3.
NOTE
For the initial set up, use the second
hole from the bottom on the wheel
hanger.
Depth Bar
Refer to figure 3.
Step 1. Attach the depth bar to the tailpiece with the
clevis pin F.
Step 2. Secure the clevis pin F with the locking pin E.
Dust Pad
Install the dust pads in each inner tine assembly. See
figure 4.
FIGURE 4. DUST PADS
Tine Assembly
Step 1. The inner tine assemblies are already assem
bled to the tiller.
Step 2. The outer tine assemblies are inverted on the
tine shaft for shipping purposes only, and
MUST be removed and turned around so that
the sharp edge of the tines enter the soil first.
Secure with bolt O and locknut P. See figure 5.