Troy-Bilt REAR-TINE TILLER 675B - Manual (Page 29)

MODEL 675B
REF
NO.
PART NO. DESCRIPTION
REF
NO.
PART NO. DESCRIPTION
1 GW-1714 Bearing, Tapered Roller with Race GW-1325C Shim Set (Inch two GW-1224-1; two 1224-
1a GW-9400 Drive Shaft Bearing Cup 2 and one GW-1224-3 (A/R)
1b GW-9401 Drive Shaft Bearing Cone 6 GW-9572 Hex Hd. Screw, 5d6-24x1-1/8*1
2 GW-20718 Spur Gear 7 GW-9944 Washer, Disc Spring (concave surface faces
3 GW-9301 Key, S16sq.x1
pulley)
4 1916597 Rolled Drive Shaft (Drive shaft is one-piece
8 1108841 Key, 316 sq. x 1-1/2
with integral, single-lead, work-hardened 9 1916522 Transmission Drive Pulley
front worm, and integral, six-lead work- 10 GW-1440 Support Washer
hardened rear worm. Also includes 11 721-04044 Oil Seal, Input Pinion Shaft
pressed-on GW-1714 and GW-9301)
12 1113527 Retaining Ring (external)
5 GW-1224-1 Shim, Rear Bearing Cap,.010" thick, see
Note below (A/R)
13
14
GW-9953
GW-9428
Thrust Washer
Bushing
5 GW-1224-2 Shim, same as above, but.030" thick, see
Note (A/R)
Shim, same as above, but.005" thick, see
15 GW-9677 Set Screw, 506-18x38*
5 GW-1224-3
16 GW-20791 Input Pinion (steel shaft)
Note (A/R) 17 GW-20792 Input Pinion Gear
5 GW-1224-4 Shim, same as above, but.062” thick, see
18 GW-9093 Retaining Ring (external)
Note (A/R) 19 GW-20799 Pinion Assy. (Incl. Refs. 16,17 & 18)
20 GW-9517 Retaining Ring
NOTE: Shim between drive shaft rear bearing and rear bearing cap to achieve 5-to-15 thousandths of an inch (.005-.015) end piay on drive shaft.
A/R - As Required
* Specify GRADE 5 if ordering part locally.
29