MTD 240-650-000 - Manual (Page 5)

INSTALLATION OF HOPPER AND UPPER LEAF RAMP
1.
Lower Leaf
Ramp Section
The lower leaf ramp section on the shredder is
placed in an upright position for shipping
purposes. Lower this section.
Place the hopper in position on the shredder.
See figure 3. Start all four hex washer head self­
tapping screws (C), then tighten securely using
a 1/2" socket wrench.
FIGURE 3.
3. Assemble the keepers (D) to the sides of the unit
with two hex washer head self-tapping screws (C),
using a 1/2" socket wrench. Tighten securely.
I
Lower Leaf
Ramp Section
Place upper leaf ramp section inside the lower leaf
ramp section. Secure with four hex bolts (A) and
— hex lock nuts (B). Tighten securely. See figure 5.
Upper Leaf
Ramp Section
FIGURE 5.