beautypg.com

MTD 24638S User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

LEFT HAND SIDE

OF SPLITTER

FIGURE4

Slide spacer (J) onto axle shaft on the left hand
side of the splitter. Spacer should be on the engine
side of the splitter. See figure 4. Place the other
wheel on the axle.

6. Secure wheel to axle with push cap (I). See figure-

5.

PUSH CAP (I)

FIGURE 5

7. Hook the bent end of the engagement rod (N)

into the lever on top of the pump. See figure 6.

Next, place one flat washer (G) over the rod.
Insert the cotter pin (H) into the hole in the rod

and secure by bending the ends of the cotter pin

in opposite directions.

FIGURE 6

See also other documents in the category MTD Tools: