MTD 113-050A - Manual (Page 6)

Blade-
Control
Handle
“Z” End of-'
Brake Cable
//
8. Snap the end of the cable into the throttle con­
trol housing. Hook the “Z” end of the brake
— cable into blade control handle. See figure 7.
FIGURE 7.
End of
Brake
Cable
NOTE
It may be necessary to push the end
of the brake cable using a screw-
■driver as shown in figure 8 to allow
enough slack for the cable to be as­
sembled to the blade control handle.
FIGURE 8.
9.
10 .
11
.
12 .
Place the throttle control lever on the handle
in “Fast” position.
Push the throttle control lever on the engine
to the full open position (as far toward the out­
side of the unit as it will go) as shown in figure
9.
Hook the “Z” end of the throttle control cable
into the hole in the control lever on the
engine.
Loosen (do not remove) the screw on the
■cable clamp shown in figure 9. Slip the control
casing under the clamp. With the throttle lever
on the engine still in the full open position,
tighten the screw to secure the throttle con­
trol cable.
FIGURE 9.