MTD 245-596-000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Place clutch plate (X) on the left hand side of the
upper handle as shown in figure 6. Secure in
place with hex bolts (H) and hex lock nuts (I).
CLUTCH
RCID (U)
HEX
LOCK-T
NUT (M)
1
COMPRESSION
SPRING (K)
HEX BOLT (J)
8.
Place hex bolt (J) through bottom hole in clutch
handle as shown in figure 7, then through hole in
adjustment bracket.
9.
Secure hex bolt with compression spring (K).
fiat washer (L) and hex lock nut (M) on the inside
of the adjijstment bracket.
FIGURE 7
10.
Place compression spring (O) over straight end
of clutch rod (U). Place end of rod in spindle
bracket assembly and secure with cotter pin (P).
See figure 8.
11.
Secure bent end of clutch rod to clutch handle
with cotter pin (P). See figure 7.
12. Slip the handle grip (N) on the end of the elute’
handle. It will slip on more easily if it is firs,
soaked in warm, soapy water.