MTD 216-320-000 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Hole Provided for

Tailpiece

“□’’-Channel

Bracket

NOTE

Wheel hanger bracket must be re

moved before the “U”-channe[ can
be pivoted down.

Pivot the “U”-channel bracket down. Place the

----- tailpiece in place in holes provided. See figure 4.

FIGURE 4.

3. Replace hex bolts in frame, which were removed

----- in step 1. Tighten securely. See figure 5.

4. Remove hex bolts and belleville washers from front

of frame. See figure 5.

FIGURE 5.

Left Hand

® Hex Bolt

and Belleville

Washer

Hex Bolt (D)

Belleville Washer (E)

Lock Washer (F)

Hex Nut (G)

HANDLE ASSEMBLY

1.----- Place the right and left hand handles in place

------- against the tiller frame. See figure 6.

NOTE

The

left

hand

handle

has

the

clutch grip preassembled. Refer to
figure 1.

Start the hex bolt and belleville washer by hand
(removed in step 4) in the bottom hole in handle.

Secure the top hole in handle with hex bolt (D),
belleville washers (E), lock washer (F) and hex nut
(G). See figure 6.

FIGURE 6.