Assembly, Depth bar installation, Note – MTD 216-406-000 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B-
E--
ASSEMBLY
FIGURE 1.
Long
I.D.
AE
NOTE
This unit is shipped WITHOUT GAS
OLINE or OIL. After assembly, see
separate engine manual for proper
fuel
and
engine
oil
recommenda
tions.
■Contents of Hardware Pack: (See Figure 1)
A
B
C
D
E
F
G
H
I
L
M
N
O
P
Q
R
S
T
u
V
w
X
(
1
)
(
1
)
(
1
)
(
1
)
(
1
)
(4)
(4)
(4)
(4)
(
2
)
(4)
(4)
(4)
(4)
(4)
(
1
)
(
1
)
(
1
)
(
1
)
(
1
)
(
1
)
(
1
)
FIGURE 2.
/
Hex Bolt 3/8-16
X
3/4" Long
Flat Washer 3/8" I.D.
Ball Knob
Clevis Pin
Hairpin Cotter
Hex Bolts 3/8-16
X
1.0"
Belleville Washers 3/8"
Lock Washers 3/8" I.D.
Hex Nuts 3/8-16 Thread
Cable Ties
Carriage Bolts 5/16-18 x 1.75" Long
Lock Washers 5/16" I.D.
Hex Nuts 5/16-18 Thread
Belleville Washers 5/16" I.D.
Hex Nuts 5/16-18 Thread
Hex Bolt V4-28 x 1" Long
Hex Lock Nut V4-28 Thread
Rubber Washer
Flat Washer 5/16" I.D. x 7/8" O.D.
Hex Lock Nut 5/16-18 Thread
Drive Clutch Lever (Not Shown)
Self-Tapping Screw (Not Shown)
■Loose Parts in Carton: (See figure 2)
AA (1) Handle—R.H.
AB (2) Side Shields
AC (1) Handle Panel
AD (1) Depth Bar Assembly
AE (1) Handle—L.H.
1. Remove tiller, loose parts and hardware pack from
carton. Make certain all parts and literature have
been removed from the carton before the carton
is discarded.
2. Extend the control cables attached to the tiller and
place on the floor. Be careful not to bend or kink
the cables.
DEPTH BAR INSTALLATION
1.----- Raise the tine shield hinge flap assembly. Insert
the depth bar assembly (AD) between the two
shoulder bolts and up through the tine shield
------- assembly as shown in figure 3.
NOTE
For clarity, figure 3 was taken with
tiller raised on end. It is not neces
sary to raise the tiller.