MTD 112-060A - Manual (Page 4)

ASSEMBLY INSTRUCTIONS
NOTE
FIGURE 1.
Upper
Handle
Lock Washer (E)
Hex Nut (C)
Lower
Curved \ \
Carriage Bolt (D) \
This unit is shipped WiTHOUT GAS­
OLINE or OIL. After assembly, see
separate engine manual for proper
fuel and engine oil recommenda­
tions.
-Contents of Hardware Pack (See Figure 1):
A (2) Shoulder Bolts 5/16-18 Thread
B (2) Belleville Washers 5/16" I.D.
C (4) Hex Nuts 5/16-18 Thread
D (2) Curved Head Carriage Bolts
E (2) Lock Washers 5/16" I.D.
F (1) Hex Bolt 1/4-20 x 1.50" Long
G (1) Hex Lock Nut V4-20 Thread
H (2) Shoulder Bolts 2-5/8" Long (Rear Wheels)
I (2) Spacers
J (8) Belleville Washers 3/8" I.D.
K (4) Hex Nuts 3/8-16 Thread
L (2) Cable Ties
M (2) Shoulder Bolts 2V4" Long (Front Wheels)
1. Remove lawn mower and all parts from the
carton. Make certain that all loose parts and
literature have been removed before the car­
ton is discarded.
2. Extend throttle control assembly which is at­
tached to engine and place on floor. Be
careful not to bend or kink control wire.
—3. Line up the upper slotted hole in lower handle
with the mounting hole on deck. Place
shoulder bolt (A) through lower handle and
deck. See figure 2.
Place belleville washer (B) on the shoulder
bolt, with the cupped side of the washer
against the deck. Secure with hex nut (C).
_ NOTE
It may be necessary to bend the
ends of the lower handle inward
slightly to obtain a snug fit against
the deck.
■4. There are two height positions for the handle.
Place upper handle in position over lower han­
dle, selecting hole for either high or low posi­
tion. Refer to figure 9. Secure with curved car­
riage bolts (D), lock washers (E) and hex nuts
(C) as shown in figure 3.
FIGURE 3.