Adjustments, Maintenance – MTD 245-660-000 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The bag may be emptied using the large zipper as
shown in figure 12. Be certain the zipper is closed
when operating the unit.
CARBURETOR ADJUSTMENT
FIGURE 12.
ADJUSTMENTS
Ai
CAUTION
Do not at any time make any adjust
ment to the unit without first stopping
engine and disconnecting spark plug
wire.
HEIGHT ADJUSTMENT
An adjusting plate and thumb lever at both Tont
wheels provide height adjustment for the vacjum.
See figure 13. Each adjusting plate has nine posilions.
Height will be changed when the thumb lever is
moved from one position to another. Simply dearess
thumb lever towards wheel and move wheel and lever
assembly to desired position. Both wheels mu ;t be
placed in the same relative position. Lower the 'ront
of the unit to obtain more suction.
A
^ WARNING )
If any adjustments are made to the
engine while the engine is running
(e.g. carburetor), disengage all clutch
es. Keep clear of all moving parts. Be
careful of heated surfaces and muffler.
If carburetor needs adjustment to start or for oper-
atidn, see "Carburetor Adjustment" section of engine
manual.
MAINTENANCE
A
|*V
arn
Î
ng
*J
Disconnect spark plug wire and ground
it against the engine before performing
any repairs or maintenance.
BAG
Under normal usage the bag is subject to wear, anc
should be checked periodically. Be sure any re
placement complies with the manufacturer's recom
mendation.
Wash
bag
periodically
with
water.
Allow to dry thoroughly in the shade. Do not use
heat.
ENGINE
Refer to engine manual for proper maintenance
procedures. Follow instructions carefully.
OFF-SEASON STORAGE
The following steps should be taken to prepare the
vacuum for storage.
1. Clean the engine and the entire unit thoroughly.
2. Refer to engine manual for correct engine storage
instructions.
3. Store in a clean, dry area.
NOTE
When storing any type of power
equipment in an unventilated or metal
storage shed, care should be taken to
rust proof the equipment. Using a
light oil or silicone, coat the equip
ment especially all moving parts.