MTD 245-660-000 - Manual (Page 5)

Slide spacers (L) onto the axle shafts. Place one
flat washer (M) on each shaft next to the spacers.
See figure 4.
SPACER (L)
AXLE
SHAFT FLAT
WASHER (M)
FIGURE 4
PUSH
CAP (N)
Place rear wheels in position on the shafts, then
another flat washer (M). Secure with black push
cap (N) by placing the push cap in position and
tapping on with hammer or rubber mallet. See
figure 5.
FIGURE 5
UPPER HANDLE
LOWER
HANDLE
Place the upper handle (C) in position over lower
handle. Fasten with four hex bolts (0) and hex
lock nuts (P) provided. See figure 6. Two
7/16" wrenches are required.
FIGURE 6