MTD 245-660-000 - Manual (Page 4)

FIGURE 1
# t>-'
L R
V
W1
FIGURE 2
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
(2) 9/16" Wrenches
(2) 7/16" Wrenches
(1) Hammer or Rubber Mallet
LOOSE PARTS IN CARTON (See figure 1):
A (1) Lower Handle
B (2) Rear Wheels
C (1) Upper Handle
D (1) Air Duct Assembly
E (1) Bag
CONTENTS OF HARDWARE PACK (See figure 2):
G (2) Hex Bolts 3/8-16 x 3/4" Long
H (2) Lock Washers 3/8" I.D.
I (4) Hex Nuts 3/8-16 Thread
J (2) Hex Bolts 3/8-16
X
1-1/2" Long
-K (2) Belleville Washers 3/8" I.D.
X
1-1/8" O.D.
L (2) Spacers 1/2" I.D. x 15/16" Long
M (4) Flat Washers 1/2" I.D.
X
1" O.D.
N (2) Black Push Caps
O (4) Hex Bolts 1/4-20 x 1-3/4" Long
P (4) Hex Lock Nuts 1/4-20 Thread
Q (1) Thumb Screw 5/16-18 Thread
R (1) Belleville Washer 5/16" I.D.
X
7/8" O.D.
S (2) Stud Pins
T (2) Push-On Speed Nuts
1 .
FIGURE 3
Remove the vacuum, loose parts, hardware pack
and literature from the carton. Make certain all
parts and literature have been removed before
the carton is discarded.
Raise the back of the unit off the floor approxi­
mately 3 inches and block it so that the lower
handle and rear wheels may be assembled.
Place lower handle (A) in position on the vacuum,
lining up the holes in the handle with the holes
on the frame. See figure 3. Place hex bolts (G)
(3/4" long) through lower hole in handle and
frame. Secure with lock washers (H) and hex
nuts (I) on the inside of frame, finger tight only.
Place hex bolts (J) through upper hole in hand'
and frame. Secure with belleville washers (K
(cupped side against the frame) and hex nuts (I).
Tighten all four nuts and bolts using two 9/16"
wrenches.