MTD 245-660-000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
9.
Place the stud pins (S) in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts (T) by holding
speed nut with box wrench and tapping pin with
hammer. See figure 7.
10. Place the tabs on the air duct assembly (D) into
the slots in the frame as shown in figure 8. Raise
the air duct into position.
THUMB
SCREW (Q)
11. Secure air duct with thumb screw (Q) and belle-
ville washers (R). Cupped side of washer must be
against the air duct. See figure 9.
FIGURES
This manual is related to the following products: