Attaching the lower [a leaf ramp section, Hex bolt, Washer f ( } ) – MTD 242A645-000 User Manual
Page 3: 5/16" i.d, To remove shredder from carton, Tools required for assembly, Attaching the upper leaf ramp section, Assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
cnn
ATTACHING THE LOWER
[A
LEAF RAMP SECTION
Hex Bolt
-5/16-18
X
8-3/8" Long
Washer f (
} )
5/16" I.D.
Hex Lock
Nut 5/16-18
Thread
*•>1^
=
B
IMPORTANT: This unit is shipped WITHOUT
GASOLINE or OIL. After assembly, see separate
engine manual for proper fuel and engine oil rec
ommendations.
NOTE:
To determine right and left hand sides of your
shredder, stand behind and face the hopper (engine
is at the front of the unit).
Your shredder has been completely assembled at the
factory, except for the hopper, lower and upper leaf
ramp sections, chute deflector and the catcher bag.
The hardware pack and safety glasses are also
included in the carton.
The hardware pack contains the parts shown in figure
1 (shown full size).
TO REMOVE SHREDDER FROM CARTON
Cut the corners of the carton. Remove all packing
inserts. Roll shredder out of carton. Make certain all
parts and literature have been removed before the
carton is discarded.
TOOLS REQUIRED FOR ASSEMBLY
(1) Phillips Screwdriver
(2) 1/2" Wrenches (one must be a socket wrench)
(2) 7/16" Wrenches or Adjustable Wrenches
ATTACHING THE UPPER LEAF RAMP SECTION
Truss Machine
Screws 1/4-20 x 1/2"
Long
Hex Lock Nuts
1/4-20 Thread
FIGURE 1.