Pci/i-a486s user's manual, Int a, Intb – Asus PCI/I-A486S User Manual
Page 19: Setting up the pci-sc 200, Default), Intc into, Jumper, Are illustrated below. thè, The card for, Convenience
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PCI/I-A486S User's Manual
Setting Up the PCI-SC200
Th^re are two jumper settings you may need to make on the card
to set it up. One setting assigii^ the FCl INT interrupt^ the other sets
the card's termination.
Setting the tfi/T Assignment
As explained in Chapter 2, any PCI card you install must use PCI
INT A. On the PCI-SC200, you assign the INT by setting jumper JPl
or JP2. The default setting for the card already is INT A, so you do
not need to change the setting to use the SC-200 with this mainbeard-
The INT
assigruTLcnt
jumper
settings
are illustrated below. Thè
settings
are
priiited on
the card for
your
convenience.
JPl & 2: interrupt settirtgs
~il S! oI
1
1
;i
—
Q_ 0_
ij
- l i - -
( 1 1
r
i l
- J ^
L J
[ j i
i
1
r i [
i
1
1 I I
i
INT A
(default)
INTB
INTC
INTO