Service, Accessories – Ariens Sno-Thro ST4-65R User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE
1. GENERAL
2. ENGINE
Ariens dealers will provide any service which
may be required to keep the Sno-Thro operating at
peak efficiency. The Sno-Thro is equipped with the
finest quality engine obtainable. However, should
servicing be required, it can be obtained from an
Ariens dealer or authorized engine manufacturer's
service station. Consult an Ariens dealer for details.
Refer to the engine instruction book and name
plate on the engine for maintenance instructions.
If repairs or service are needed for engine, see an
Ariens dealer or nearest authorized engine service
station.
ACCESSORIES
1. SLICER BAR (3-10M)
2. TIRE CHAINS (1-10M)
The slicer bar is available as
optional
equipment
for
Model
10M4. The SLICER BAR is de
signed to cut through deep snow
and dislodge crusted or drifted
snow. The bar can be installed on
either side of the SNO-SCOOP.
Figure 5
Tire chain kit number 1-lOM is available for
3x12 semi-pneumatic tires.
3. TIRE CHAINS (2-10M)
Tire chain kit number 2-lOM is available for
4:00x6 pneumatic tires.
4.
PNEUMATIC TIRE KIT (6-10M)
Pneumatic tire kit 6-lOM is available for Model
10M4 Sno-Thro.