Cisco 10BASE-FL - Manual (Page 14)

14 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
VIP2 and the 5EFL Port Adapter
Figure 9 Location of Port Adapter Screw (Partial Port Adapter View)
Step 6 Remove the screw that secures the port adapter (or blank port adapter).
Step 7 With the screw removed, grasp the handle on the front of the port adapter (or blank port
adapter) and carefully pull it out of its slot, away from the edge connector at the rear of
the slot. (See Figure 10.)
Figure 10 Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)
Step 8 If you removed a port adapter, place it in an antistatic container for safe storage or
shipment back to the factory. If you removed a blank port adapter, no special handling is
required; however, store the blank port adapter for potential future use.
H3148
Screw
H3149