Controls, Controis – Asus 136-480A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 4.
3. Cut the black rubber tubing approximately 4
Inches long.
4. Push the rubber tubing into the manifold of
the battery and place the other end into the
drain tube. See figure 4.
Dov.n
Neg.
i .
.. .■,<
FIGURES.
CONTROLS
The controls on both models may be considered
as the Drive Control and the Cutting Control as
follows:
a. Throttle Control. The throttle control is used to
regulate the engine speed and choke the engine.
The engine should be operated from % to full
throttle when operating the cutting deck or snow
thrower (optional). See figure 6.
NOTE
The vented battery allows any gases
or liquid from the battery to be car
ried to the rear of the mower through
the drain tube.
5. Hook the hold down rods under the battery
case and place the hold down over the
manifold of the battery as shown In figure 5.
6. Secure the hold down with the wing nuts.
7. Attach the positive cable (from the starter
solenoid) and the small wire (from the
ammeter) to the positive battery terminal with
the bolt, lockwasher and nut in the assembly
pack.
8. Attach the negative cable, grounded, to the
negative battery terminal with the bolt,
lockwasher and nut in the assembly pack.
FIGURE 6. CONTROLS
b. Gear Shift Lever. The gear shift lever is used to
shift into one of four Forward Gears, NEUTRAL or
REVERSE. See figures 6 and 7.