Cutting height - swivei models, Operation (continued) – Ariens 911 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operation (Continued)
Cutting Height - Swivei Models
To change front wheel cutting height, insert clevis pin
into the holes that corresponds to the desired cutting
height. (Figure 4).
Swivel Models
STARTING
To change rear wheel cutting height, move cutting
height levers one notch at a time until the desired
cutting height is obtained. (Figure 4)
1.
Cutting Height Lever
2.
Notches
3.
Clevis Pin & Swivel Height Adjustment Holes
4.
Grease Fitting
5.
Swivel Lock Hole (Clevis Pin Thru To Lock)
6.
Lynch Pin Storage Hole (Clevis Pin Thru To
Swivel)
A
WARNING: DO NOT attempt to start
your engine at this time. Familiarize
yourself with controls to see what they
do, how they work and thoroughly read
and
understand
entire
Operator's
Manual first.
1.
Wheel Drive Control (Self Propelled Model)
2.
Engine Control
3.
Primer
4.
Rewind Starter
5.
Speed Selector (Self Propelled Model)
6.
Key Switch (Electric Start Model)
7.
Throttle Control (Professional Models Only)
Figures: Controls