Threading machine – SINGER WF111 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THREADING MACHINE
b)
c)
d)
To prevent breaking of the upper thread, it is essential to thread the machine as described below:
a)
Bring needle to its highest position by turning the balance wheel toward you.
Place the spool of thread on one of reel holder pin at the back of arm, and lead the thread
to the notched thread guide ( 3 ) .
Draw the thread down throngh the Tension Discs i26) from right to left.
Draw the thread up over the Wire Check Spring (27) and through the eye of the Retaining
Thread Guide Bar (28) from right to left.
e)
Now take the thread up through the eye of Take Up
Lever ( 2 ) and down through the thread guide (24) .
f)
Then hook into
Wire Guide (24) attached to the
Needle Clamp and
finally pass it from right to left
through
the
eye
of
the
needle,
leaving
about
four
inches of thread hanging free.
The
machine
is
now
ready
for
sewing.
It
is
important
once
the
machine
is
threaded,
to
make certain that
the
presser
foot
is
down,
and
that
there
is
fabric
between
presser
foot
and
needle
plate.
Failure
to
observe
this
precaution may cause the threads to get tangled underneath
the needleplate, jam the shuttle hook and damage or break
the needle.
Note : Refer the Numbers to P. 1.
GO-