Threading the machine – SINGER 384.18024 (Sold at Sears) User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
• Threading the machine
*
Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
*
Place a spool on the spool pin, with thread coming off as
shown.
U] Draw the end of thread around the upper thread guide.
[
2
] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[
3
] Firmly draw the thread up from right to left over the take-up
lever and down into the take-up lever eye.
E Slide the thread behind the needle bar thread guide on the
left.
[5] Thread the needle from front to back or use a needle
threader.
• Drawing up bobbin thread
rn Raise the presser foot. Hold the needle thread lightly with
your left hand and turn the handwheel counterclockwise
for one complete turn.
|j] Bring the bobbin thread up by pulling the needle thread
up.
1
Pull both threads under and to the back of the presser
foot, leaving 4.0” to 6.0” (10.0 to 15.0 cm) of thread clear.
28