Built-in buttonhole [models 415 & 426 – SINGER W426 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
t
BUILT-IN BUTTONHOLE
[MODELS 415 & 426]
This buttonhole eliminates the need for pivoting
the fabric. It is used most often on light and
medium woven fabrics.
1. Set the stitch width control for the red square
marked (1) buttonhole position. Lower needle
into the mark at the top left end of buttorv
hole Lower jarosser foot and sew on the left
edge of buttonhole until you reach the bottom
end of buttonhole.
2 Stitch width control to the (2-4) position
take a few stitch to bartack the bottom end
of buttonhole.
3. With the needle up, turn the stitch width
control to the (3) position. Sew on the right
edge of buttonhole.At this position the ma
chine is feeding in reverse.- ' •
4. With the needle out of the cloth, turn again to
the (2-4) position and complete the button
hole by barracking on the top edge
buttonhole.
of
To lock the stitches, make sure the needle is
out of the fabric and set width at 0 and feed
dog height down. Then take a few stitches.
6. To prevent cutting through the bartack insert
a straight pin through the bartack. Cut
buttonhole open.
Pattern: M or manual
Length: Buttonhole
Width: 1-2-3-4
Feed Dog: High-Down
Pressure: Full
Foot: Buttonhole Foot
Stretch Stitch: M
32