Upper threading – SINGER W1315 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Fig. 9

PLACING BOBBIN
CASE IN SHUTTLE

Raise needle bar to

highest position, and lift
hinged cover plate. (See

11, Fig. 1.) Hold the bob

bin case latch, (D), Fig. 9,
between the thumb and
forefinger of the left hand,
with at least three inches
of thread running from

the top of the bobbin case to the right. Insert and
center the bobbin case on the stud of the shuttle

body, (C). Be sure the bobbin case finger, (E), is
opposite the shuttle race notch, (A). Press the bobbin
case (B) into the shuttle as far as possible until latch
catches on the center post of the shuttle. THEN

release the bobbin case latch, (D). Press bobbin

case again after latch has been released to make
sure the bobbin case is locked securely in place.
Close the cover plate.

UPPER THREADING

(Fig.

10)

1) Place spool of thread on spool pin nearer the

needle

2) lead thread through upper thread guide A on

back of face plate

3) down and around tension discs B from back to

front

Fig. 10