Winding a bobbin – SINGER 1872 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Winding a bobbin
Preparation Steps
1. Raise the presser foot and turn hand wheel toward you until needle is in highest position.
2. Loosen hand wheel knob A by turning it toward you with the right hand while holding hand
wheel with the left hand.
3. Place thread spool on spool pin with thread retaining slit B on top. (Break paper at the end of
spool if necessary).
Winding Steps
• Lead thread around bobbin winder tension disc C, as illustrated, and through small hole in
bobbin from inside out.
• Place bobbin on spindle and move bobbin winder D to right.
• Hold thread end and start the machine. Cut off thread end after a few coils have been wound.
• When required amount of thread has been wound (winding will stop when bobbin is full) stop
machine and cut connecting thread.
• Move bobbin winder to the left and remove bobbin.
• Hold hand wheel and tighten hand wheel knob.