SINGER 14U11 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(2) Thread the overedge looper in sequence from 0 to (6) (marked in orange color).
Wind thread around thread
guide when threading (2) as
shown in figure below.
Tension
discs
While holding thread with finger,
pass it between the tension discs
and pull thread down to make
certain it is properly located in
between the tension discs.
Use tweezer provided in the accessory set when
threading looper thread hole (6).
Draw about 5cm (2 inches) of thread from the
looper thread hole.
This manual is related to the following products: