SINGER 185K User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
t
Place spool of thread on spool pin.
Thread machine as shown above.
Hold end of thread and start machine. (End
of thread will break off after a few coils
have been wound on bobbin.)
When bobbin is full—
• Stop machine.
• Lift bobbin winder away from hand wheel.
• Remove bobbin.
• Tighten stop motion screw.
If thread doesn't wind evenly on bobbin—
• Loosen the screw which holds thread guide
to bed of machine.
• Turn guide to left if bobbin winds high on
right.
• Turn guide to right if bobbin winds high on
left.