Chaining off and test sewing – SINGER 14U244 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12.
CHAINING OFF AND TEST
SEWING
* When the machine is completely threaded, bring
all of the threads over the throat plate and slightly
to the left under the presser foot.
* Hold the threads and apply a slight tension.
* Turn the hand wheel toward you 2 or 3 complete
turns to start the thread chain.
* Lower presser foot.
* Continue holding the chain and press on the foot
control until the chain is 5 ~ 7.5 cm (2
3 inches)
in length.
* Place fabric under the front of the presser foot and
sew a test sample.
Note:
Do not pull on the fabric while sewing as this
may deflect the needle, causing it to break.
* At the end of the sample, continue to run the
machine with the presser foot down until the
chain reaches 5 ^ 7.5 cm (2
3 inches) in length.
* Clip the thread chain.
Note:
Anytime you have rethreaded the machine
always chain off and sew a test sample to test
tensions and make adjustments as necessary.
18