Hemming -hemming foot optional – SINGER W1410 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HEMMING -HEMMING FOOT OPTIONAL
Presser foot.....................................hemmer foot
Pattern selector................................M r~*~))
Stitch length dial.............................. 1 to 4
Raise the foot and the needle to its highest position. Replace the
foot with the hemmer foot.
Fold over the fabric edge by about 3 mm (1/8 inches) and place it
under the foot. Secure the folded edge with a few stitches. Take
out the workpiece and draw the hem into the hemmer foot by
pulling on the threads.
Lower the foot and sew the hem.
During sewing, fold the fabric to the left a little and allow it to
run Into the hemmer foot
Make sure that the fabric does not move under the right half of
the foot. The fabric must be fed into the scroll of the hemmer
sufficiently so that the workpiece edge runs freely through the
groove under the foot.
E
DiinO ' f .If f
26-