SINGER W1410 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WlNDiNG THE SOBsiN
1. Release clutch
by Turning
clutch
knob
Toward you.
2. Draw thread from spool through
bobbin winder tension disc as shown.
3. Pull end of thread through hole m
bobbin
as
shown. .
4. Place bobbin onto bobbin winder
shaft with end of thread coming from
the top of the bobbin. Push' bobbin
winder shaft to the right until it clicks.
Holding onto end of thread, start
machine. When bobbin is slightly
fillea, snip oft end of thread.
5.
Wind thread until winder stops.
Remove bobbin. Clip thread.
6. Tighten clutch knob.
14-
This manual is related to the following products: