SINGER W117 - Manual (Page 2)

Certificate of guarantee
We guarantee to the original purchaser the sew­
ing head of this machine when used for normal
family use to be free from defects in material
and workmanship for a period of twenty years
from date of purchase. In the event that %vorking
parts prove to be defective in material or woi-k-
manship, they will be replaced free of charge if
the machine is returned to the nearest Sears
or Simpsons-Sears retail or mail order store. In
returning to a mail order store, be sure and pack
securely. (Needles, belts, bobbins, shuttles, bulbs,
or parts which wear out from natural use are ex­
cluded from the guarantee.)
We further guarantee all electrical equipment to
be free from defects for a period of one year from
date of purchase. • ‘
When referring to this guarantee or when writ­
ing us about your machine, always mention the
model number.
We do not authorize any person or representative
to make any other guarantee or to assume for us
any liability in connection with the sale of this
sewing machine other than those contained here­
in. Any agreements outside or contradictory to
the foregoing shall be void and of no effect.
For ready reference record the number of your
machine on this page.
Model No.
Cabinet Model No.
Head Serial No.
Date Delivered
SEARS. ROEBUCK AND CO.
and SIMPSONS-SEARS LIMITED
The Object of This Book
_is Lo provide you with complete directions for
operating this sewing machine. We are extremely
anxious that your investment in this machine re­
turns the utmost in satisfactory service. Therefore
you arc urged to read this book carefully ami thor­
oughly ill order to familiarize yourself with the
operation of this sowing machine, even though you
may be accustomed to using some other make.
To Install Sewing Machine Head
On Cabinet
Place the head on top of open cabinet and slide
iiead hinge lug holes (Fig. 2) over round shanks of
the two hinges attached to back of cut-out in top of
cabinet. Tip head back and tighten head hinge set
screws (Fig. 2) securely.
Pull bushing up on motor cord as near to the
motor as possible and slip motor cord into slot at
edge of bed plate and push bushing back into hole
in bed plate (see Fig. 9). Unwind the extension
cord inside the cabinet, plug into any base plug
outlet, and the machine is ready for operation.
If machine is treadle operated, merely place
leather belt around hand wheel drive pulley as of
course there is no motor or electrical connections.
IMPORTANT
GIVE PARTICULAR ATTENTION TO IMPOR­
TANT INFORMATION ON PAGES 11 AND 12.
One