SINGER W164 User Manual

Page 26

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

THE SET OF HEMMERS

Before attaching any of the hemmers be sure

bobbin thread is pulled up. Then, with hemmer in

place, hold top thread loosely and turn handwheel one

full turn toward you, making a loop under hemmer.

Grasp

bobbin

thread

with

both

hands

and

slip

horizontally

under

hemmer

toward

back.

Bobbin

thread will catch loop and carry upper thread to back

of hemmer.

Fold material to suit for two inches along edge,

hold at each end of fold.

Slip fold into guide and

up over spoon (Fig. 38). Fold hem in material back of hemmer. Draw forward to end of hem

and fasten with point of needle. Pull on threads gently as you start stitching.

H E M M E R S E T

You can make a hem 1/4", 3/8", 5/8" or 7/8" in width, depending upon

which hemmer you use. For a few of the many uses see Figs 39, 40, 41, 42,

43, and 44.