Applique work – SINGER W1010 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
18. APPLIQUE WORK
Set machine as shown.
Draw design on material to be
used as an applique and cut it out.
Place cut-out on base material
and baste it.
Sew around outline with zigzag
stitch adjusting stitch length and
width
according
to
shape
and
size of cut-out and type of base
material.
To change direction at corners,
or to sew very small circles, stop
machine,
positioning
needle
just
away from edge of cut-out, lift
presser foot and turn material.
Lower presser foot and continue
sewing.
Sew a few stitches at end with
zigzag width at 0.
This is to prevent unstitching.
-37-