Setting up your machine, The position of thread pole, Cone holders – SINGER WSL1634 User Manual

Page 8: Spool caps, Settong up your machine -8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING UP YOUR MACHINE

Set your Overlook machine on a sturdy flat

surface.

[ THE POSITION OF THREAD POLE ]

Pull up thread pole to its highest point before

TuTr^the^thread pole so the thread guides

come right above the spool pins.

[ CONE HOLDERS

Both industrial cones and domestic type thread
spools can be used on this machine.

For large diameter industrial cones use the
cone holders with the large end at the top^

For small diameter cones, use the same cone
holders with the small end at the top.

[ SPOOL CAPS ]

When using domestic type thread spools

remove the spool holders and place spool
caps over the thread spools.