Sears KEMORE 758.144533 - Manual (Page 9)

Replacement and Care of Filters
WARNING: To reduce the risk of
shock or injury from moving
parts, always unplug humidifier
before removing or replacing any
parts._________________________
CAUTION: To help retard bacteria
growth and keep maximum effi­
ciency, the filters should be
replaced at least once a season, or
more often under hard water condi­
tions. Use Sears recommended
replacement filter.
All filters may be rinsed in clear water
only. Take care not to damage paper.
To replace the evaporative wicking filters
in your Kenmore Quiet Comfort Whole
House humidifier, follow the instructions
below.
1. Unplug humidifier, and proceed to
clean. Before removing the filters, we
recommend moving the humidifier to
an area where floor coverings are not
susceptible to water damage, i.e.
kitchen or bath areas.
2. Open the pivoting lid and remove
water bottles and set aside. Grasp the
fan assembly front center and rear
center. Lift off and set aside on a clean
flat surface. The filter assemblies are
now accessible..
3. Lift fitter housings out of cabinet and
place where you may work on them
comfortably. With a soft, absorbent
cloto remove any remaining water or
loose mineral deposits not trapped in
the filter from the humidifier cabinet.
4. To open filter housing for easy access
to filters:
a. Deflect the two spring tabs on top
of filter housing. Lift top cover off of
the filter housing and set aside.
b. Remove the two filters and dispose
of properly. Clean internal parts of
humidifier per the “Cleaning of
Humidifier” section of your owner's
manual.
Spring