Sears KEMORE 758.144533 - Manual (Page 6)

Water Fill (continued)
Notice the water bottles are designed as
right and left hand units. Position them in
the correct location so the humidifier can
function properly. The water bottles
should rest in the front of the cabinet.
Each “E-Z-Fill Side-Cap” must be lacing
the rear of the unit.
Each water bottle is designed with an
“E-Z-Fill Side-Cap” that is easily remov­
able. Remove the “E-Z-Fill Side-Cap” on
the side of the water bottle by twisting
counterclockwise.
Place the opening of the water bottle under
a water fiaucet (the bottle should fit under a
four-inch clearance faucet). Fill with recom­
mended mixture of cold water and Sears
Bacteriostat #42-14900 only. Solid debris
could make the valve leak.
Install the "E-Z-Fill Side-Cap” by twisting
clockwise. Hand tighten only.
Check for possible leaks by performing
the following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on valve cap plunger for about
one second to let out a little water.
3. Release the plunger.
4. Listen for air bubbles. Look for leaks
around “E-Z-Fill Side-Cap”.
5. If you -hear air bubbles or see leaks,
retighten “E-Z-Fill Side-Cap” and repeat
steps 1-4.
■
Wipe off excess water from the bottle.
Position the water bottle back into the unit.
Grasp the water bottle handle, and lower
into the cabinet until the bottle sits on
pads at bottom of cabinet. The “E-Z-Fill
Side-Cap" must be facing the rear of the
cabinet. When positioned properly, the
plunger will open and water will flow into
the cabinet. The water level will automati­
cally remain at approximately 1/2" until
the bottles are empty.
The unit is now ready for operation.
Face Rear
Turn Counterclockwise
to Remove Cap
Valve
Cap Plunger