Sears KEMORE 758.144533 - Manual (Page 10)

Replacement and Care of Filters (continued)
c. Install new filters in the filter hous­
ing track with the glue beads of the
wicking pad to the inside of the filter
housing.
d. Return the top cover of the filter
housing by installing the cover over
the fixed tabs on the rear of the
lower filter housing and pivoting the
cover down over the top of the fil­
ters. Snap the cover over the two
spring tabs.
e. Replace the filter housing in the
cabinet. Note: There is a left and a
right filter housing. There is also a
front and back orientation. To posi­
tion the filter housings correctly:
• Make sure the two indents in the
cylinder section of the top covers
are positioned towards the center
of the cabinet.
• Be sure that the spring tabs of fil­
ter housings are towards front of
cabinet.
• Align the lower portion of the filter
assembly over the six ribs located
at the bottom rear of the humidi­
fier cabinet.
f. Position fan assembly onto the cab­
inet. Make sure the fan venturi (low­
est cylinder section below the fan)
is placed inside the filter housing.
g. Replace water bottles.
h. Close the pivoting lid on the fan
assembly.
i. The unit is ready for use or to be
'stored away for next season.
NOTE; For correct operation of the filter
housing assembly, filters must be fully
contained inside the flange of the top
cover.
Fixed
Tabs
Flat Portion of Filter Housing
Towards Back of Cabinet
Indents Toward Center
of Cabinet
Step 4.e.
10