Sears KENMORE 437.83163 - Manual (Page 6)

step 5
Locate the seam of the pre-filter and carefully
separate the pre-filter from the strap fastener
and remove from the HEPA filter. Step 8
.Remoy.e^any,prqteciive-plastic wrapping from
'the new HÈPA filter. Follow the Instructions in
Step 6 to secure the new pre-filter around the
HEPA filter.
Step 6
Remove any plastic protective wrapping
from the new pre-filter prior to insertion into
the HEPA Air Cleaner.
Secure
approximately Vi inch of the strap
fastener to one edge of the carbon side of the
pre-filter.
Carefully wrap the new pre-filter
around the HEPA filter and secure it to the
strap fastener. Once fastened the white side
of the pre-filter should be exposed to view. If
the
HEPA filter does not need replacing,
proceed to step 9.
Step7,8&9-Changing the HEPAfilter(ltem
#831 54)
Step 7
The pre-filter must be replaced when the HEPA
filter is replaced. Remove and discard pre­
filter (follow instruction Steps 1 - 5). Next
remove and- discard the used HEPA filter
assembly.
NOTE: These specially designed, maximum
performance filters are made for easy
replacement. THEY ARE NOT WASHABLE.
Step 9
Place the Filter Assembly (pre-filter plus HEPA
filter) into the POWER HEAD and install the
Base.
NOTE: The HEPA filter has no special top-to-
boUom orientation. It v/ill fit easily from either
end into the Power Head.
Step 10
Once the filter assembly is correctly inserted,
lock
the Base into place by replacing and
tightening the Locking Handle securely.
Step 11
Turn the HEPA AIR CLEANER upright and it is
ready for operation.
P ower H ead S trap F ashtener
H epa F ilter
L ocking K nob
I nner C harcoal P re -F ilter
O uter W hite P re - filter
NOTE: The strap fastener should be attached to the Inner
carbon side of the pre-filter assembly.