Sears KENMORE 437.83163 - Manual (Page 5)

S et - up
visually.inspect Ihe HEPA Air Cleaner upon
removing the unit from its box. Remove and
discard
any packaging material. Return the
unit if it shows any signs of damage or
mishandling.
This unit was thoroughly
inspected and tested at the factory prior to
packaging.
' ‘
CAUTION
Never operate the'
HEPA air cleaner without the HEPA
filterproperly installed, permanent motor
damage could result.
E
lectrical hook
-
up
Plug the air cleaner into a polarized 120 Volt
AC. wall outlet.
WARNING
To avoid fire or shock hazard, the
HEPA air cleaner should ‘ ohiy be
plugged into a polarized 120 Volt
AC. outlet.
O
peration
Adjust the power/control switch to the desired
output setting:
SUPER - Fast Initial cleaning
HIGH - Daytime operation - fast fan speed
LOW - Night-time quieter operation
Turn IONIZER switch ON.
F ilter CARTRIDGE replacement
s t e p 1 .
Turn the HEPA Air Cleaner OFF and unplug
the unit from the power outlet.
Step 2
To open, gently place the air cleaner on it’s
side.
Unscrew the LOCKING HANDLE to
release the BASE from the air cleaner.
LCXJKING KNOB
L
BASE
C
leaning Ste p o
NOTE: PRIOR TO ANY CLEANING
OPERATION, THE HEPA AIR CLEANER
MUST BE TURNED OFF AND UNPLUGGED
FROM THE POWER OUTLET.
Remove the BASE assembly from the air
cleaner.
Steps 4, 5 & S - Replacing the carbon
Impregnated pre-filter (Item #83166).
Clean the HEPA aircieaner’s external surfaces
with a moistened soft cloth only. Do Not
Directly Wet With Water Or Any Abrasive
Type Cleaner. Clean all external surfaces
especially the Air Intake and Exit grills.
Step 4
. Remove the Filter Assembly (consisting of
the HEPA filter and pre filter) from the Power
Head. ^
'