Sears 831.23953.0 - Manual (Page 8)

4. Tip: Avoid pinching the Main Wire (42). Slide
the Upright (2) onto the Frame (1).
Have a second person hold the Shield Cover
(37) out of the way.
Attach the Upright (2) with five M10 x 20mm
Screws (79) and five M10 Split Washers (78).
Tip: Start all the Screws before fuily tighten­
ing them.
Press the Shield Cover (37) into the Left and
Right Shields (44, 45).
5. Orient the Handlebar (39) as shown. Have a
second person hold the Handlebar near the
Upright (2).
Locate the Sensor Wires (93) in the Handlebar
(39). Insert the right Sensor Wire into the right
side of the Upright and insert the left Sensor
Wire into the left side of the Upright. Pull the
Sensor Wires upward out of the top of the
Upright.
Tip: Avoid pinching the wires. Attach the
Handlebar (39) to the Upright (2) with three M10
X 20mm Screws (79).
8