Sears 831.29074 - Manual (Page 4)

ASSEMBLY
For your convenience, the ARC SKIER PLUS is shipped assembled in the stowaway position. Follow the instruc­
tions below to set up the ARC SKIER PLUS. No tools are required.
1. Raise the Upright (26) to the position shown. Slide
the M10 Washer (18) onto the Lock Knob (30). Insert
the Lock Knob into the indicated bracket and tighten
the Lock Knc^ info the lower end of the Upright
2. The Console (27) requires two ‘AA" batteries (not
included). Alk^ine batteries are recommended.
To install batteries, first slide up the Battery Cover
(46). Carefully remove the battery clip from the
Console (27). Insert two batteries into the battery
clip. Make sure that the negative (-) ends of the
batteries are touching the springs. Insert the bat­
tery clip into the Console and close the Battery
Cover.
3. Before using №e cross-oiuntry skier, the included sil­
icon oil should be applied. Apply a few drops of sili­
con oil to the Ski Rails (1) where the Ski Pedal
Wheels (23) make contact.
Bracket
Battery Clip
Make sure that all parts are securely tightened. The use of the remaining parts will be explained in the following
section.