Sears 9-29012 - Manual (Page 15)

Controls
Guard Tab
Control
Guard Tab
Function
Provides manual way to raise
dear plastic guard during rip­
ping when workpiece fails to
raise it
Qperation/CfT/n/ncnw
Push and hold until workpiece
clears guard, then release
Pawls/Riving
Knife Knob Frees pawls and riving knife to
independently move up and
down Turn counterclockwise to
loosen, clockwise to tighten
Pawls
Riving Knife
During ripping, slow or stop
kickback by digging into work­
piece; when lowered during
crosscutting, provide partial bar­
rier to leading edge of blade
Reduces kickback by keeping
kerf open; wlien lowered during
ciossculiing, provides partial
bruTier to leading edge of blade
For ripping, set paw! level on
workpiece surface. For safety
reasons set pawls before rip­
ping, See Ripping Set-Up for
details and ilbistrations
For ripping, lower to table
For safety reason'i riving knife
must he in line with blade See
Alignment' Riving Knife to
Blade
15