To install shifter lever knob, To check/adjust clutch control cables, Assembly – Sears Craftsman 536.886531 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
TO INSTALL SHIFTER LEVER KNOB
® Thread the shifter lever knob onto the threaded end
of the shifter lever until it is snug against the hex nut
and the lip is pointed toward the engine Tighten the
hex nut against the bottom of the shift lever knob (See
Fig 6),
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables. Fig 7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
before you use your snow thrower
For instructions on checking or adjusting the control
cables, see To Adjust Clutch Control Cables paragraph on
page 18.