Sears 32025 - Manual (Page 13)

REMOVABLE KNOBS
All control knobs may be removed for easy cleaning by
pulling the knob straight off the stem. Be sure that the
knob Is In the OFF position before removal.
Hint: Slip a thin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull up.
Caution: Read these instructions carefully
before replacing the knobs. Replacing
the knobs improperly will damage the
knobs and the spring clip on the stems.
If
this happens, the knobs will fit
loosely.
To replace the knob;
1. Match the flat side of the "D” Shaft on the knob to the
flat side of the stem and replace knob.
BEFORE CALLING FOR SERVICE
PROBLEM SOLUTION
Cooktop knobs virill not turn
Push knobs In to turn.
Cooktop burners will not light Gas supply not connected or not turned on.
Counter unit not properly grounded or polarized.
This can affect spark ignition. See installation
section.
No electricity to unit; check for tripped fuse or
circuit breaker. Be sure unit is plugged In.
Soil clogging holes in burner top. Remove and
clean.
Ticking sound of spark igniter persists after burner
lights
Spark igniter not deactivated. Turn burner off and
relight. Some ticking is normal. If ticking is exces­
sive, call for service.
Ticking sound of spark igniter persists after burner
is turned off
Soil buildup at back of knob. Be sure knob is In the
OFF position. Pull knob straight off stem and
check back of knob for any soil buildup.
Heavily soiled or stained chrome cooktop cannot be
satisfactorily cleaned See the instructions under cleaning tips, for clean­
ing chrome cooktops with oven cleaner. This
procedure requires extreme caution. Read in­
structions carefully.
12 NGCUS02