Sealed burner assemblies, Burner heads, Burner caps – Sears 61118 User Manual
Page 22: Care and cleaning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Care and Cleaning
Proper care and cleaning are important so your range
will give you efficient and satisfactory service. Follow
these directions carefully in caring for it to help assure
safe and proper maintenance.
BE SURE ELECTRICAL POWER IS
DISCONNECTED BEFORE CLEANING ANY
PART OF YOUR RANGE.
Sealed Burner Assemblies
(on some models)
CAUnONi DO NOT OPERATE THE BURNER
WITHOUT ALL BURNER PARTS AND DRIP
PANS (IF SO EQUIPPED) IN PLACE.
Ttirn all the controls off before removing burner
parts and drip pans {if so equipped).
The burner grates, caps, heads and drip pans
(if so equipped) can be lifted off, making them easy
to clean.
Eiectrode
The electrode of
the spark igniter is
exposed when the
burner head is
removed. When one
burner is turned to LITE, all the burners spark
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to knock
over hot coolcware.
Burner HeAds
(on sealed burners only)
For proper ignition,
make
sure the small hole in the
section that fits over the
eiectrode is kept open.
A sewing needle or wire
twist-tie works well to undog it.
The slits in the burner heads of vour ranee
unhampered flame.
You should dean the surface burners routinely,
especially after bad spillovers, which could clog these
openings.
To remove hurned-on food,
soak the burner heads
in a solution of mEd liquid detergent and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before putting the burner head back,
shalcc out
excess water and then dry it thoroughly by setting it in
a warm oven for 30 minutes.
Replace the burner caps. Make sure that caps are
replaced on the correct ske burner. There is one small,
2 medium and one large cap.
NOTE; On some models the caps are all the same size
and can be used in any of the 4 needed locations.
Burner Caps
(on sealed burners only)
Lift off when cool. Wash burner caps in hot, soapy
water and rinse with dean water. You may scour with a
plastic scouring pad to remove burned-on food partldes.
Dry them in a warm oven or with a doth—-don’t
reassemble them wet. Replace the burner caps.
Smali*
Medium -
L.3.rQS "
fr-M.——
Medium
Medium
-© G- Small
'
— |_0}'g9
22
Front of Ranqe
Make sure that caps are replaced on the correct ske
burner. There is one smali, 2 medium and one large cap.
NOTE: On some models the caps are all the same ske
and can be used in any of the 4 needed locations.